2001 Toyota RAV4 Owners Manual - Page 37

4. Push the "TIME SET" button again. The display goes out and the timer setting completes. If you fail to push the "TIME SET" button here, the timer cannot be set. 5. Push the "TIMER CHARGE" button. The charger enters the timer charging mode and the "TIMER CHARGE" light comes on. 6. Push the "PRE A/C" button. 7. Insert the charge coupler within 3 minutes from step 5. Charging starts and stops automatically when the traction batteries are charged. To cancel the timer setting, push the "TIMER CHARGE" button again. If you insert the charge coupler after the set start charging time, charging starts at the set time of the next day. 8. To stop charging in the middle of the operation, pull out the charge coupler. Do not remove the charge coupler until the preheating/precooling start time. The "TIMER SET" function on the vehicle will be canceled. If the charge coupler is removed from the charge port before the "SET TIME" function is activated, perform the following steps. D Place the charge coupler back in the holder of the EVSE to reset the timer unit. D Reset the "TIME SET" function for the appropriate time. 3. Push the "TIME SET" button again to show the preheating/precooling start time on the display. To change the time, enter the desired start time with the "H" and "M" buttons in consideration with the time you start driving. Move the temperature selector lever toward "WARM" or "COLD". You do not need to operate the fan speed selector at this time. 4. Push the "TIME SET" button again. The display goes out and the timer setting completes. 5. Push the "TIMER CHARGE" button. The charger enters the timer charge mode and the "TIMER CHARGE" light comes on. 6. Push the "PRE A/C" button. 7. Insert the charge coupler within 3 minutes from step 5. To cancel the setting, push the "TIMER CHARGE" button again. If you insert the charge coupler after the set start charging time, charging starts at the set time of the next day. 8. To stop preheating/precooling in the middle of the operation, pull out the charge coupler. D Insert the charge coupler back into the charge port. (4) Setting preheating/precooling for vehicle interior only PROCEDURE 1. Push the "TIME SET" button to show the current time on the display. If the displayed time is not correct, enter the correct time with the "H" and "M" buttons. 2. Push the "TIME SET" button again to show the charging start time on the display. Push the "H" button several times until "---" is displayed. 29