2001 Toyota Sienna Owners Manual - Page 250

2001 Toyota Sienna Manual

Page 250 highlights

01 SIENNA_U (L/O0008) If your vehicle will not start- (a) Simple checks Before making these checks, make sure you have followed the correct starting procedure given in "How to start the engine" in Section 3 and that you have sufficient fuel. If your vehicle is equipped with the engine immobiliser system, also check whether the other keys will start the engine. If they work, your key may be broken. Have the key checked at your Toyota dealer. If none of your keys work, the system is possibly broken. Call your Toyota dealer. (See "Keys (with engine immobiliser system)" in Section 1 −2.) If the engine is not turning over or is turning over too slowly- 1. Check that the battery terminals are tight and clean. 2. If the battery terminals are O.K., switch on the interior light. 3. If the light is out, dim or goes out when the starter is cranked, the battery is discharged. You may try jump starting. See "(c) Jump starting" for further instructions. If the light is O.K., but the engine still will not start, it needs adjustment or repair. Call a Toyota dealer or qualified repair shop. (b) Starting a flooded engine NOTICE Do not pull − or push−start the vehicle. It may damage the vehicle or cause a collision when the engine starts. Also the three−way catalytic converter may overheat and become a fire hazard. If the engine turns over at its normal speed but will not start- 1. Turn the ignition key to "ACC" or "LOCK" and try starting the engine again. 2. If the engine does not start, check that all the push−on connectors are tight. (For example, connectors at the spark plugs, ignition coil and/or distributor) 3. If the connectors are O.K., the engine may be flooded because of repeated cranking. See "(b) Starting a flooded engine" for further instructions. If the engine will not start, your engine may be flooded because of repeated cranking. If this happens, turn the key to "START" with the accelerator pedal held down. Keep the key and accelerator pedal these positions for 15 seconds and release them. Then try starting the engine with your foot off the accelerator pedal. If the engine does not start after 15 seconds of cranking, release the key, wait a few minutes and try again. If the engine still will not start, it needs adjustment or repair. Call a Toyota dealer or qualified repair shop for assistance. NOTICE Do not crank for more than 30 seconds at a time. This may overheat the starter and wiring systems. 250 2001 MY SIENNA (OM45406U)

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.