2001 Toyota Solara Owners Manual - Page 151

'01 SOLARA_U (L/O 0009) 2. Bring the hand held garage door opener to within about 25 mm (1 in.) of the button being programmed and push the button on the hand held garage door opener. The signal from the hand held garage door opener is sent to the vehicle's opener. 3. When the frequency and code is registered, the indicator light flashers rapidly. At this point, your can release both buttons. 4. To program the remaining buttons, repeat steps 1 through 3. If the transmitter has a rolling code feature, it is necessary to program the in-garage receiver after programming HomeLinkr. 1. Locate the training or learning button on the in-garage receiver and push and release this button. Location of the button may vary among garage door opener manufacturers. 2. Firmly push and release the trained HomeLinkr button 2 times (some garage door manufacturers may require you to push the HomeLinkr button up to 3 times) to complete the process. The garage door should now operate when the HomeLinkr button is pushed. Do not use the HomeLinkr universal transmitter with any garage door opener that lacks the safety stop and reverse feature as required by Federal Safety Standards. This includes any garage door opener model manufactured before April 1, 1982. CAUTION When programming or operating the garage door opener, make sure there is no one around the moving door. (b) Operating the garage door opener Push the appropriate button to activate the garage door opener. The indicator light comes on. The garage door opener continues to send the signal as long as the button is pushed (up to 20 seconds). (c) Erasing the memory garage door opener NOTICE Canada only: As your hand held garage door opener may automatically stop sending the signal during programming, press and re-press the hand held garage door opener button every two seconds during steps 1 through 4 above until the frequency and code is registered. If you want to replace an existing program with a new program, select the button you want to program. Follow the procedure from step 1. Push and hold down the 2 outside buttons for about 20 seconds until the indicator light flashes. All memorized data will be erased. 2001 MY SOLARA (OM33527U) 151