2001 Toyota Tundra Owners Manual - Page 224

'01 TUNDRA_U (L/O 0008) -Loosening wheel nuts -Positioning the jack Front Rear 4. Loosen all the wheel nuts. Always loosen the wheel nuts before raising the vehicle. Turn the wheel nuts counterclockwise to loosen. To get maximum leverage, fit the wrench to the nut so that the handle is on the right side, as shown above. Grab the wrench near the end of the handle and pull up on the handle. Be careful that the wrench does not slip off the nut. Do not remove the nuts yet-just unscrew them about one-half turn. 5. Position the jack at the correct jack point as shown. Make sure the jack is positioned on a level and solid place. JACK POINTS: Front-Under the frame side rail Rear-Under the rear axle housing Access cab models-Put a jack handle, jack handle extension and jack handle end together as shown in the illustration. 1 Jack handle end 2 Jack handle extension 3 Jack handle 2001 TUNDRA (OM34416U) 213