2002 Toyota RAV4 Owners Manual - Page 186

'02 Rav4_U (L/O 0108) JUMP STARTING PROCEDURE 1. If the booster battery is installed in another vehicle, make sure the vehicles are not touching. Turn off all unnecessary lights and accessories. 2. If required, remove all the vent plugs from the booster and discharged batteries. Lay a cloth over the open vents on the batteries. (This helps reduce the explosion hazard, personal injuries and burns.) 3. If the engine in the vehicle with the booster battery is not running, start it and let it run for a few minutes. During jump starting, run the engine at about 2000 rpm with the accelerator pedal lightly depressed. Discharged battery Positive terminal ("+" mark) Booster battery Positive terminal ("+" mark) Jumper cable Discharged Jumper battery cable Booster battery Negative terminal ("-" mark) 4. Make the cable connections in the order a, b, c, d. a. Connect the clamp of the positive (red) jumper cable to the positive (+) terminal on the discharged battery. b. Connect the clamp at the other end of the positive (red) jumper cable to the positive (+) terminal on the booster battery. c. Connect the clamp of the negative (black) cable to the negative (-) terminal on the booster battery. d. Connect the clamp at the other end of the negative (black) jumper cable to a solid, stationary, unpainted, metallic point of the vehicle with the discharged battery. The recommended connecting point is shown in the following illustration: 186 2002 MY RAV4_U (OM42503U)