2002 Toyota Tacoma Owners Manual - Page 185

'02 Tacoma U (L/O 0109) Floor mat Installing front license plate (four-wheel drive models and Pre Runner) Valance panel Longer tapping screws Shorter Front license plate tapping screws Use a floor mat of the correct size. If the floor carpet and floor hole, then it is designed for locking clip. Fix the floor mat clip into the hole in the floor mat have a use with a with locking carpet. CAUTION Make sure the floor mat is properly placed on the floor carpet. If the floor mat slips and interferes with the movement of the pedals during driving, it may cause an accident. Install the front license plate using the following procedure: 1. Remove and discard the front license plate frame (if installed on the vehicle at delivery). 2. Align the holes on the front license plate with the dimples on the valance panel. 3. Install the two longer tapping screws through the upper holes, and the two shorter tapping screws through the lower holes of the license plate, into the dimples on the valance panel. Do not drill holes in the dimples on the valance panel. 2002 MY TACOMA_U (OM35786U) 185