2003 Toyota 4Runner Owners Manual - Page 666

'03 4Runner_U (L/O 0211) Checking the engine oil level Low level Full level With the engine at operating temperature and turned off, check the oil level on the dipstick. 1. To get a true reading, the vehicle should be on a level spot. After turning off the engine, wait a few minutes for the oil to drain back into the bottom of the engine. 2. Pull the dipstick out, hold a rag under the end and wipe it clean. If the oil level is below or only slightly above the low level, add engine oil of the same type as already in the engine. Remove the oil filler cap and add engine oil in small quantities at a time, checking the dipstick. We recommend that you use a funnel when adding oil. The approximate quantity of oil needed to fill between the low level and the full level on the dipstick is indicated below for reference. When the level reaches within the correct range, install the filler cap hand-tight. Oil quantity, L (qt., lmp. qt.): 1.5 (1.6, 1.3) Add oil O.K. Too full 1GR-FE engine 3. Reinsert the dipstick-push it in as far as it will go, or the reading will not be correct. 4. Pull the dipstick out and look at the oil level while holding a rag under the end. Low level Full level NOTICE CAUTION Be careful not to touch the hot exhaust manifold. z Be careful not to spill the engine oil on the vehicle components. z Avoid overfilling, or could be damaged. the engine NOTICE Add oil O.K. Too full z Check the oil level on the dipstick once again after adding the oil. Be careful not to drop the engine oil on the vehicle components. 2UZ-FE engine 320 2003 4RUNNER from Oct. '02 Prod. (OM35804U)