2003 Toyota Corolla Owners Manual - Page 210

'03 Corolla U (L/O 0201) Checking the engine oil level NOTICE Low level Full level ENGINE OIL SELECTION Use API grade SL "Energy −Conserving" or ILSAC multigrade engine oil. Recommended viscosity: SAE 5W−30 Be careful not to drop the engine oil on the vehicle components. If the oil level is below or only slightly above the low level, add engine oil of the same type as already in the engine. Add oil O.K. Too full Remove the oil filler cap and add engine oil in small quantities at a time, checking the dipstick. We recommend that you use a funnel when adding oil. The approximate quantity of oil needed to fill between the low level and the full level on the dipstick is indicated below for reference. When the level reaches within the correct range, install the filler cap hand−tight. Oil quantity, L (qt., lmp. qt.): 1.3 (1.4, 1.1) SAE 5W−30 is the best choice for good fuel economy, and good starting in cold weather. If SAE 5W−30 oil is not available, SAE 10W−30 oil may be used. However, it should be replaced with SAE 5W−30 at the next oil change. With the engine at operating temperature and turned off, check the oil level on the dipstick. 1. To get a true reading, the vehicle should be on a level spot. After turning off the engine, wait a few minutes for the oil to drain back into the bottom of the engine. 2. Pull the dipstick out, hold a rag under the end and wipe it clean. 3. Reinsert the dipstick-push it in as far as it will go, or the reading will not be correct. 4. Pull the dipstick out and look at the oil level while holding a rag under the end. Outside temperature NOTICE z Be careful not to spill the engine oil on the vehicle components. z Avoid overfilling, or could be damaged. the engine z Check the oil level on the dipstick once again after adding the oil. 2003 MY COROLLA_U (OM12744U) 210