2003 Toyota MR2 Spyder Owners Manual - Page 256

03 07.07 Checking power steering fluid If the level is low, add SAE J1703 or FMVSS No.116 DOT 3 brake fluid to the brake reservoir. Remove and replace the reservoir cap by hand. Fill the brake fluid to the dotted line. This brings the fluid to the correct level when you put the cap back on. Use only newly opened brake fluid. Once opened, brake fluid absorbs moisture from the air, and excess moisture can cause a dangerous loss of braking. If cold O.K. Close Open If hot O.K. SB72002 If cold add If hot add Clean all dirt from outside of the reservoir tank and look at the fluid level. If the fluid is cold, the level should be in the "COLD" range. Similarly, if it is hot, the fluid level should be in the "HOT" range. If the level is at the low side of either range, add Toyota P.S fluid EH or equivalent to bring the level within the range. To remove the reservoir cap, turn it counterclockwise and lift up. To reinstall it, turn it clockwise. After replacing the reservoir cap, visually check the steering box case, vane pump and hose connections for leaks or damage. CAUTION Take care when filling the reservoir because brake fluid can harm your eyes and damage painted surfaces. If fluid gets in your eyes, flush your eyes with clean water immediately. If you still feel uncomfortable with your eyes, go to the doctor. Check the fluid level through the reservoir. If necessary, add Toyota P.S fluid EH or equivalent. Before checking the power steering fluid, remove the cover inside the trunk. (See "Replacing light bulbs" on page 226 in Section 7-3.) If the vehicle has been driven around 80 km/h (50 mph) for 20 minutes (a little more in frigid temperatures), the fluid is hot (60°C-80°C or 140°F-175°F). You may also check the level when the fluid is cold (about room temperature, 10°C-30°C or 50°F-85°F) if the engine has not been run for about five hours. CAUTION The reservoir tank may be hot so be careful not to burn yourself. NOTICE Avoid overfilling, or the power steering could be damaged. NOTICE If you spill the fluid, be sure to wash it off with water to prevent it from damaging the parts or paint. 210 2003 MR2 from Aug. '03 Prod. (OM17511U)