2003 Toyota Sequoia Owners Manual - Page 774

03_SEQUOIA_U (L/O 0301) Replacing wheels CAUTION WHEN TO REPLACE YOUR WHEELS If you have wheel damage such as bending, cracks or heavy corrosion, the wheel should be replaced. If you fail to replace a damaged wheel, the tire may slip off the wheel or cause loss of handling control. WHEEL SELECTION When replacing wheels, care should be taken to ensure that the wheels are replaced by ones with the same load capacity, diameter, rim width, and offset. Correct replacement wheels are available at your Toyota dealer. A wheel of a different size or type may adversely affect handling, wheel and bearing life, brake cooling, speedometer/odometer calibration, stopping ability, headlight aim, bumper height, vehicle ground clearance, and tire or snow chain clearance to the body and chassis. Replacement with used wheels is not recommended as they may have been subjected to rough treatment or high mileage and could fail without warning. Also, bent wheels which have been straightened may have structural damage and therefore should not be used. Never use an inner tube in a leaking wheel which is designed for a tubeless tire. D Do not exceed 50 km/h (30 mph) or the chain manufacturer's recommended speed limit, whichever is lower. D Drive carefully avoiding bumps, holes, and sharp turns, which may cause the vehicle to bounce. D Avoid sharp turns or locked−wheel braking, as use of chains may adversely affect vehicle handling. CAUTION Observe the following instructions. Otherwise, an accident may occur resulting in death or serious injuries. D When driving with chains installed, be sure to drive carefully. Slow down before entering curves to avoid losing control of the vehicle. Otherwise an accident may occur. D Do not use wheels other than the manufacturer's recommended size, as this may cause dangerous handling characteristics resulting in loss of control. D Four−wheel drive models: Do not use brands, sizes may cause characteristics control. wheels of different and types, as this dangerous handling resulting in loss of 368 2003 SEQUOIA from Jan. '03 Prod. (OM34422U)