2003 Toyota Sienna Owners Manual - Page 23

03 SIENNA_U (L/O 0207) RESETTING THE DOOR SYSTEM POWER SLIDING If the power sliding door system operates incorrectly or does not operate under the following conditions, the system must be initialized and reset by the steps in the next column. 1. Be sure to turn off the power sliding door system by pushing in the "PWR DOOR OFF" switch. 2. Disconnect the battery for 1 minute and then reconnect it. 3. Close the sliding door by hand. (Step 3 can be performed before step 2.) 4. Turn on the power sliding door system by pushing out the "PWR DOOR OFF" switch. 5. Wait 5 seconds. 6. Open the sliding door by using one of the "DOOR L", "DOOR R" and "PWR DOOR" switches. 7. Wait 3 seconds after the sliding door stops at the fully −opened position. 8. Close the sliding door by using one of the "DOOR L", "DOOR R" and "PWR DOOR" switches inside the vehicle or "POWER DOOR", "D−PWR DOOR" and "P−PWR DOOR" switches of the wireless remote control transmitter. 9. Wait 3 seconds after the sliding door stops at the fully −closed position. 10. Repeat the steps from 6 to 9. D The battery is disconnected and then reconnected, or a discharged battery is recharged. In this case, initialize and reset the system by doing the following steps from 6 to 10. CAUTION When the vehicle is stopped on a downward slope of a steep grade (17% or more), the sliding door may not stay in the fully−opened position and could suddenly close by itself, possibly resulting a personal injury. Making sure the sliding door does not close abruptly, turn on the power sliding door system. Then the sliding door will operate under the control of the electric power. D The open power sliding door warning light stays on though the sliding door is closed. In this case, initialize and reset the system by doing the following steps from 1 to 10. CAUTION To initialize and reset power sliding door system, stop the vehicle on a level ground. 2003 MY SIENNA (OM45410U) 23