2003 Toyota Tundra Owners Manual - Page 557

'03 TUNDRA_U (L/O 0301) -After changing wheels 11. Check the air pressure of the replaced tire. Adjust the air pressure to the specification designated in Section 8. If the pressure is lower, drive slowly to the nearest service station and fill to the correct pressure. Do not forget to reinstall the tire inflation valve cap as dirt and moisture could get into the valve core and possibly cause air leakage. If the cap is missing, have a new one put on as soon as possible. 12. Restow all the tools, jack and flat tire securely. With a spare tire of the same wheel type as the installed tires- As soon after changing wheels as possible, tighten the wheel nuts to the torque specified in Section 8 with a torque wrench. Have a technician repair the flat tire. With a spare tire of different wheel type from the installed tires- As soon after changing wheels as possible, tighten the wheel nuts to the torque specified in Section 8 with a torque wrench. Have a technician repair the flat tire and replace the spare tire with it. CAUTION Before driving, make sure all the tools, jack and flat tire are securely in place in their storage location to reduce the possibility of personal injury during a collision or sudden braking. Type E 10. Reinstall the wheel ornament. 1. Put the wheel ornament in position. Type A-Align the cutout of the wheel ornament with the valve stem as shown. 2. Then firmly tap the outer edge of the wheel cap with the side or heel of your hand to snap it into place. CAUTION Take due care in handling the ornament to avoid unexpected personal injury. 237 2003 TUNDRA from Jan. '03 Prod. (OM34421U)