2004 Toyota Sienna Navigation Manual - Page 335

04 SIENNA_U (L/O 0408) Headlight beam level control High- Low beams-For high beams, turn the headlights on and push the lever away from you (position 1). Pull the lever toward you (position 2) for low beams. The headlight high beam indicator light (blue light) on the instrument panel will tell you that the high beams are on. Flashing the high (position 3)-Pull the back. The high beam when you release the beam headlights lever all the way headlights turn off lever. TURN SIGNALS To signal a turn, push the headlight/ turn signal lever up or down to position 1. The key must be in the "ON" position. The lever automatically returns after you make a turn, but you may have to return it by hand after you change lanes. To signal a lane change, move the lever up or down to the pressure point (position 2) and hold it. If the turn signal indicator lights (green lights) on the instrument panel flash faster than normal, a front or rear turn signal bulb is burned out. To adjust the headlight beam level, turn the dial. The following list shows examples of proper switch settings. For loading conditions other than those listed, adjust the dial position so that the beam level is the same as the one obtained according to the list when only the driver is in the vehicle. The higher the number of the dial position, the lower the headlight beam level. Always keep the headlight beam at the proper level, or your headlights may dazzle other road users. You can flash the high beam headlights with the knob turned to "OFF". 153 2004 SIENNA from Aug. '04 Prod. (OM45422U)