2004 Toyota Sienna Navigation Manual - Page 383

04 SIENNA_U (L/O 0408) When the ignition is turned off, all the preset data is cleared. When you use the dynamic laser cruise control again, you need to reset the data. CAUTION To avoid accidentally engaging the cruise control, keep the "ON- OFF" button off when not using the dynamic laser cruise control. If you need to accelerate-for example, when passing-depress the accelerator pedal enough for the vehicle to exceed the preset speed. When you release the accelerator pedal, the vehicle will return to the control prior to acceleration. You cannot set a desired speed if the master warning light comes on, the alarm sounds and the display indicates one of the warning codes "E1", "E2" or "E3". If any of the above codes appears on the display, see "VEHICLE- TO- VEHICLE DISTANCE CONTROL MODE FAILURE WARNING" on page 206. SETTING THE DESIRED SPEED The transmission must be in "D" before you set the cruise control speed. Bring your vehicle to the desired speed, push the lever down in the "- SET" direction and release it. This sets the vehicle at that speed. At this time, the display indicates settings such as the preset vehicle speed, whether a vehicle is present ahead and selected vehicle- to- vehicle distance. If there is no vehicle detected ahead, the display does not indicate the vehicle ahead. You can now take your foot off the accelerator pedal. CANCELLING THE PRESET SPEED You can cancel the preset speed by doing any of the following: a. Pulling the direction. lever in the "CANCEL" b. Depressing the brake pedal. c. Pressing the "ON- OFF" button. If cancelled by a. or b., the "READY" indicator comes on and the dynamic laser cruise control enters the ready mode. If cancelled by c., the "CRUISE" indicator light goes off in the instrument panel. In this case, the preset speed data is cleared, and you must set the speed from the beginning. 201 2004 SIENNA from Aug. '04 Prod. (OM45422U)