2005 Toyota 4Runner Owners Manual - Page 616

'05 4Runner_U (L/O 0504) -Replacing tires and wheels D Reorient or relocate the receiving antenna. When replacing the wheels, be sure to install air pressure sensors on the wheels. There are 3 ways to set up the air pressure sensors: a. Remove the sensor from the old wheel and install it to the new wheel. b. Keep the same wheel with air pressure sensor and replace only the tire. c. Use a new wheel and sensor. In this case, you have to register an ID code for a new sensor. Parking brake D Increase the separation between the equipment and receiver. D Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. D Consult the dealer or an experienced radio/TV technician for help. FCC WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. For vehicles sold in Canada Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. CAUTION Have the tires, placed and ID Toyota dealer. purchase from wheels or sensors recodes registered by a If you need sensors, a Toyota dealer. When parking, firmly apply the parking brake to avoid inadvertent creeping. To set: Fully depress the parking brake pedal. For better holding power, first depress the brake pedal and hold it while setting the parking brake. To release: Depress the parking brake pedal once again. To remind you that the parking brake is set, the parking brake reminder light in the instrument panel remains on until you release the parking brake. 192