2005 Toyota MR2 Spyder Owners Manual - Page 204

04 09.01 Positioning the jack ADDING WASHER FLUID Parts: CAUTION When jacking, be sure to observe the following to reduce the possibility of personal injury: D Water D Washer fluid containing antifreeze (for winter use) Tools: D Funnel REPLACING LIGHT BULBS Parts: SB71008 Front of vehicle D Follow jacking instructions. D Do not put any part of your body under the vehicle supported by a jack. Personal injury may occur. D Bulb with same number and wattage rating as original (See charts in "Replacing light bulbs-" on page 228 in Section 7 −3.) Tools: When jacking up your vehicle with the jack, position the jack correctly as shown in the illustration. Jack position ...Front-Front crossmember Rear-Rear engine mounting bracket Support position and Pantograph jack position ... D Do not start or run the engine while your vehicle is supported by the jack. D Stop the vehicle on a level firm ground, firmly set the parking brake and put the transmission in reverse. Block the wheel diagonally opposite to the one being changed if necessary. D Screwdriver D Make sure to set the jack properly in the jack point. Raising the vehicle with jack improperly positioned will damage the vehicle or may allow the vehicle to fall off the jack and cause personal injury. D Never get under the vehicle when the vehicle is supported by the jack alone; use vehicle support stands. 204 2005 MR2 from Aug. '04Prod. (OM17527U)