2005 Toyota Solara Owners Manual - Page 18

'05 Solara_U (L/O 0409) -Activating alarm -Switching beep sound You can switch the beep on and off. (The beep is on initially and after battery replacement.) To switch the beep on and off: With the driver's door opened- 1. Insert the ignition key and remove it. 2. Within 5 seconds, insert the ignition key again and turn it to the "ON" position. 3. After 10 seconds, push any switch on the transmitter twice within 10 seconds. Two beep sounds inform you that the program has been switched on or off. If this procedure is not followed exactly, the beep will not operate as expected. Check the beep ON/OFF operation by pushing the transmitter switch after you finish this procedure. If the beep does not operate as expected, repeat this procedure from step 1. -Replacing battery For replacement, use a CR2032 lithium battery or equivalent. CAUTION Special care should be taken to prevent small children from swallowing the removed transmitter battery or components. NOTICE z When replacing the transmitter battery, be careful not to lose the components. z Replace only with the same or equivalent type recommended by a Toyota dealer. z Dispose of used batteries according to the local laws. Replace the transmitter battery by following these procedures: Pushing the switch blows the horn intermittently and flashes the headlights, tail lights, turn signal lights, and interior light (coupe) or personal lights (convertible). The alarm switch is used to deter vehicle theft when you witness anyone attempting to break into or damage your vehicle. The alarm will last for one minute. To stop alarm midway, push the switch once again, unlock a door with transmitter, or turn the ignition key from the "LOCK" to "ON" position. The alarm does not work when the ignition key is in the "ON" position. 18 2005 SOLARA from Sep. '04 Prod. (OM33690U)