2005 Toyota Tundra Owners Manual - Page 204

'05 TUNDRA_U (L/O 0408) -Replacing tires and wheels When replacing the wheels, be sure to install air pressure sensors on the wheels. There are 3 ways to set up the air pressure sensors: a. Remove the sensor from the old wheel and install it to the new wheel. b. Keep the same wheel with air pressure sensor and replace only the tire. c. Use a new wheel and sensor. In this case, you have to register an ID code for a new sensor. To initialize the system, perform the following: 1. Park the vehicle at a safe place and apply the parking brake. Stop the engine. 2. Adjust the pressure of all the installed tires to the specified level. (See "Tires" in Section 8.) 3. Turn the ignition key to "ON". 4. Push and hold the reset switch until the low tire pressure warning light blinks three times. TIRE PRESSURE RESET SWITCH WARNING SYSTEM Initialization is completed over for more than 20 minute. CAUTION Have the tires, placed and ID Toyota dealer. purchase from wheels or sensors recodes registered by a If you need sensors, a Toyota dealer. The tire pressure warning system need to be initialized in the following conditions: D After replacing or rotating tires or wheels D After replacing an air pressure sensor. When initializing the system, the present tire condition is stored as a standard. 204 2005 TUNDRA from Aug. '04 Prod. (OM34427U)