2006 Toyota Camry Owners Manual - Page 309

'06Camry_U (L/O 0507) Checking the engine oil level Low level Full level Low level Full level 4. Pull the dipstick out and look at the oil level while holding a rag under the end. CAUTION Be careful not to touch the hot exhaust manifold. Add oil O.K. Too full Add oil O.K. Too full NOTICE Be careful not to drop engine oil on the vehicle components. If the oil level is below or only slightly above the low level line, add engine oil of the same type as already in the engine. Remove the oil filler cap and add engine oil in small quantities at a time, checking the dipstick. We recommend that you use a funnel when adding oil. The approximate quantity of oil needed to raise the level between low and full on the dipstick is indicated as follows: 2.4 L 4−cylinder (2AZ−FE) engine 1.0 L (1.1 qt., 0.9 Imp. qt.) 3.0 L V6 (1MZ−FE) and 3.3 L V6 (3MZ− FE) engines 1.5 L (1.6 qt., 1.3 Imp. qt.) 2.4 L 4−cylinder (2AZ−FE) engine (type A) 3.0 L V6 (1MZ−FE) and 3.3 L V6 (3MZ−FE) engines Low level Full level With the engine at operating temperature and turned off, check the oil level on the dipstick. 1. To get a correct reading, the vehicle should be on level ground. After turning off the engine, wait a few minutes for the oil to drain back into the bottom of the engine. 2. Pull the dipstick out, hold a rag under the end and wipe it clean. 3. Reinsert the dipstick-push it in as far as it will go, or the reading will not be correct. Add oil O.K. Too full 2.4 L 4−cylinder (2AZ−FE) engine (type B) 309 2006 CAMRY from July '05 Prod. (OM33708U)