2006 Toyota Camry Owners Manual - Page 328

'06Camry_U (L/O 0507) Adding washer fluid If the new fuse immediately blows out, there is a problem with the electrical system. Have your Toyota dealer correct it as soon as possible. You should normalize the moon roof if it does not operate automatically or the jam protection function does not operate correctly after replacing blown fuses. To normalize the moon roof, see "Electric moon roof" on page 35 in Section 1 −2. If any washer does windshield washer light comes on, the empty. Add washer not work or the low fluid level warning washer tank may be fluid. Replacing light bulbs- The following illustrations show how to gain access to the bulbs. When replacing a bulb, make sure the ignition switch and light switch are off. Use bulbs with the wattage ratings given in the table. CAUTION Never use a fuse with a higher amperage rating, or any other object, in place of a fuse. This may cause extensive damage and possibly a fire. You may use plain water as washer fluid. However, in cold areas where temperatures range below the freezing point, use washer fluid containing antifreeze. This product is available at your Toyota dealer and most auto parts stores. Follow the manufacturer's directions for how much to mix with water. CAUTION D To prevent burning yourself, do not replace the light bulbs while they are hot. D Halogen bulbs have pressurized gas inside and require special handling. They can burst or shatter if scratched or dropped. Hold a bulb only by its plastic or metal case. Do not touch the glass part of a bulb with bare hands. NOTICE Do not use engine antifreeze or any other substitute because it may damage your vehicle's paint. NOTICE Only use a bulb of the listed type. 328 2006 CAMRY from July '05 Prod. (OM33708U)