2006 Toyota Highlander Owners Manual - Page 172

'06 HIGHLANDER HB_U (L/O 0503) Resetting the system The system must be reset after the engine oil replacement. Reset the system by the following procedure. 1. Turn the ignition key to the "LOCK" position with the odometer reading shown. For details, see "-Odometer and two trip meters" on page 154 in this Section. 2. Turn the ignition key to the "ON" position while holding down the trip meter reset knob. A message "MAINT REQD RESET MODE" will appear on the display. 3. Hold down the knob at least 5 seconds. A message "COMPLETE" will appear and a beep will sound. (e) This message is to remind the driver that the washer fluid level is low. If the washer fluid level is low, the message appears with the master warning light and warning tone when the ignition is on. If the message appears, fill the washer tank as soon as possible. For instructions, see "Adding washer fluid" on page 403 in Section 7−3. (f) This message is to warn the driver that the vehicle stability control (VSC) function of the vehicle dynamics integrated management (VDIM) is malfunctioning. If a malfunction is detected, the message appears with the master warning light and warning tone when the ignition is on. If the message appears, the functions of VDIM listed below may not work properly. Have the vehicle checked by a Toyota dealer as soon as possible. (g) This message is to warn the driver that the engine oil pressure is too low. If the engine oil pressure is too low, the message appears with the master warning light and warning tone when the ignition is on. If the message appears, turn the hybrid system off as soon as possible and contact a Toyota dealer. (h) This message is to warn the driver that the hybrid system is almost overheating. If the coolant temperature is too high, the message appears with the master warning light and warning tone when the ignition is on. D Traction control function D Vehicle stability control function 159 2006 HIGHLANDER (Hybrid) from Mar. '05 Prod. (OM48530U)