2006 Toyota Highlander Owners Manual - Page 347

'06 HIGHLANDER HB_U (L/O 0503) BRAKES AND SAFETY CHAINS D Toyota recommends trailers with brakes that conform to any applicable federal and state/provincial regulations. between the towing vehicle and the trailer. Leave sufficient slack in the chain for turns. The chain should cross under the trailer tongue to prevent the tongue from dropping to the ground in case it becomes damaged or separated. For correct safety chain procedures, follow the hitch or trailer manufacturer's recommendations. D Never tow a trailer without using a safety chain securely attached to both the trailer and the vehicle. If damage occurs to the coupling unit or hitch ball, there is danger of the trailer wandering over into another lane. TIRES D A safety chain must always be used D Ensure that your vehicle's tires are properly inflated. See page 391 in Section 7−2 and page 415 in Section 8 for instructions. D The trailer tires should be inflated to the pressure recommended by the trailer manufacturer in respect to the total trailer weight. TRAILER LIGHTS D Your vehicle is equipped with a wire harness stored in the rear end under body. Some models are fitted with a socket for trailer lights under the rear bumper. Use either of them to connect and operate the trailer lights. However, the trailer lights must comply with federal, state/provincial and local regulations. See your local recreational vehicle dealer or rental agency for the correct type of wiring and relays for your trailer. Check for correct operation of the turn signals and stop lights each time you hitch up. Direct splicing may damage your vehicle's electrical system and cause a malfunction of your lights. CAUTION D If the total trailer weight exceeds 453 kg (1000 lb.), trailer brakes are required. D Never tap into your vehicle's hydraulic system as it would lower its braking effectiveness. 334 2006 HIGHLANDER (Hybrid) from Mar. '05 Prod. (OM48530U)