2006 Toyota Land Cruiser Owners Manual - Page 181

-Selector switch If the low tire pressure warning light does not blink when you push and hold the reset switch, have the tire pressure warning system checked at your Toyota dealer. ID codes should be registered by Toyota dealer. Once registered, change the setting position each time you purchase tires and wheels. Re- registration is not required. NOTICE z Do not turn the engine switch off during initialization, or the system may not function properly due to incomplete initialization. z Check which tires are being used before initialization of the system, and also check the selector switch position. (See the following "Selector switch".) 16C524a When purchasing new tires, consult your Toyota dealer. CAUTION When the tires whose ID code is registered at "MAIN" are used, the system does not work properly with the selector switch set at "2nd". If the tires whose ID code is registered at "2nd" are stored nearby, the system will detect their tire inflation pressure (and vice versa). 1. Main position 2. 2nd position The selector switch is located in the glove box. The ID code is given in the tire pressure sensor. To activate the tire pressure warning system, it is necessary to register the ID code of the sensor on the selector switch in the vehicle. 2 sets of ID codes can be registered. The code of the tires originally installed on the vehicle is registered on the switch at "MAIN". Have a new tires set with new tire pressure sensors registered at "2nd" by Toyota dealer. 154