2006 Toyota Matrix Owners Manual - Page 113

'06 MATRIX_U (L/O 0508) If the light comes on while driving, adjust tire inflation pressure to the specified level. (See "Tires" on page 306 in Section 8.) After the tire inflation pressure is adjusted, push the tire pressure warning system reset switch for a few seconds and make sure the warning light goes off. If the light still remains or blinks once a second, have the low tire pressure warning system checked at your Toyota dealer. If the light blinks once every three seconds, the low tire pressure warning system needs to be initialized. For details, see "Tire pressure warning system" on page 126 in Section 1 −7. (m) Low Windshield Washer Fluid Level Warning Light (for vehicles sold in Canada) The light warns that the windshield washer fluid level is too low. Add washer fluid at your earliest opportunity. (For instructions, see "Adding washer fluid" on page 291 in Section 7−3.) (n) Engine Oil Replacement Reminder Light (for vehicles sold in U.S.A.) This light reminds you when to replace the engine oil. This light will come on when the ignition key is turned to "ON" and will go off after about a few seconds. When you drive for about 7200 km (4500 miles) after the engine oil replacement, this light illuminates for about 3 seconds and then flashes for about 12 seconds with the ignition key turned to the "ON" position. If you continue driving without replacing the engine oil, and if the distance driven exceeds 8000 km (5000 miles), the light will come on after the ignition key is turned to "ON" position. The light will remain on thereafter. If the light is flashing, we recommend that you replace the engine oil at an early opportunity depending on the driving and road conditions. If the light comes on, replace it as soon as possible. The system must be reset after the engine oil replacement. Reset the system by the following procedure: 1. Turn the ignition key to the "ACC" or "LOCK" position with the odometer reading shown. (For details, see "Odometer and two trip meters" on page 104 in this Section.) 2. Turn the ignition key to the "ON" position while holding down the trip meter reset knob. Hold down the knob for at least 5 seconds. The odometer indicates "000000" and the light goes off. If the system fails to reset, the light will continue flashing. (o) Key Reminder Buzzer This buzzer reminds you to remove the key when you open the driver's door with the ignition key in the "ACC" or "LOCK" position. (p) Light Reminder Buzzer This buzzer will sound if the headlight switch is left on and the driver's door is opened with the key removed from the ignition switch. 113