2006 Toyota Sienna Owners Manual - Page 330

06 SIENNA_U (L/O 0603) 2. Lock the seat legs and push any switch other than the stowing switch. Seat operation will stop if any one of the switches shown in the illustrations is pushed. At this time the indicator light above the switches comes on and a beep sounds for about 10 seconds. If the engine is started during operating, the seat operation may also be stopped. To continue the returning operation, the seatback must be back to the folded position first. Operation from inside CAUTION When folding or returning the seats, observe the following precautions in order to prevent personal injury: D Make sure that the seat path is clear before moving the seat. Otherwise, injury may result from contact with the seat. D Be careful not to allow hands or feet to get caught or pinched in the seat. When returning the seats to their original position, make sure the seat belts are not twisted or caught in the seatback. It could result in serious injuries in a sudden braking or a collision. Do not shift the automatic transmission selector lever out of "P" with the ignition key in "ON" during the operation. Doing so may cause the vehicle to move and result in serious personal injury. RETURNING THIRD SEATS Push one of the switches shown in the illustrations. The seatback returns to its original position. If the indicator light above the switches flashes three times when the switch is pushed, the returning operation will not start. To continue the operation, do the following: 1. Operation from outside only-Open the back door when the ignition key is in "LOCK" or "ACC" and/or the automatic transmission selector lever is in "P". 98 2006 SIENNA from March '06 Prod. (OM45443U)