2006 Toyota Tacoma Owners Manual - Page 620

06 01.06 When initializing the system, the present tire condition is stored as a standard. To initialize the system, perform the following: 1. Park the vehicle at a safe place and apply the parking brake. Stop the engine. 2. Adjust the pressure of all the installed tires (including the spare tire) to the specified level. (See "Tires" on page 400 in Section 8.) 3. Turn the ignition key to "ON". 4. Push and hold the reset switch until the low tire pressure warning light blinks three times. When initializing the system, make sure the low tire pressure warning light blinks three times. If the warning light does not blink three times, initialization failed and the tire pressure warning system will not function properly. In this case, initialize the system again. Do not push the reset switch without adjusting the tire inflation pressure to the specified level. Otherwise, the low tire pressure warning light may not come on even if the tire pressure is low, or it may come on when the tire inflation pressure is actually normal. If you push the reset switch while the vehicle is moving, initialization is not performed. If the low tire pressure warning light does not blink when you push and hold the reset switch, have the low pressure warning system checked at your Toyota dealer. LS17025 CAUTION Initializing the system must be performed with all tires (including the spare tire) adjusted to the specified tire inflation pressure. NOTICE Initialization is completed within a few minutes. When warning light blinks after driving of about 20 minutes, try to initialize again. 198 2006 TACOMA from Jan.'06 Prod. (OM35865U)