2007 Toyota 4Runner Owners Manual - Page 442

06 06.07 D If you cannot adjust the tire pressure when the tires are cold, add 20 to 30 kPa more to the front tires and rear tires than the cold tire pressure, but never exceed the maximum cold tire pressure molded on the tire sidewall. D Always use a tire pressure gauge. The appearance of a tire can be misleading. Besides, tire inflation pressures that are even just a few pounds off can degrade ride and handling. D Do not bleed or reduce tire inflation pressure after driving. It is normal for the tire inflation pressure to be higher after driving. D Never exceed the vehicle capacity weight. Passenger and luggage weight should be located so that the vehicle is balanced. Tire pressure gauge CY72019 5. After completing the tire inflation pressure measurement and adjustment, apply soapy water to the valve and check for leakage. 6. Install the tire valve cap. If a gauge and air pump are not available, have your vehicle checked by your Toyota dealer. CAUTION Be sure to reinstall the tire valve caps. Without the valve caps, dirt or moisture could get into the valve core and cause air leakage. If the caps have been lost, have new ones put on as soon as possible. NOTICE INSPECTION AND ADJUSTMENT PROCEDURE 1. Remove the tire valve cap. 2. Press the tip of the tire pressure gauge to the tire valve. 3. Read the pressure using the graduations of the gauge. 4. In case the tire inflation pressure is not within the prescribed range, insert the compressed air from the valve. In case of applying too much air, press the center of the valve and release the air to adjust. Use only the original valve cap. If any other valve cap is used, it may corrode or melt and become difficult or impossible to remove. 426 2007 4Runner from Aug. '06 Prod. (OM35866U)