2007 Toyota 4Runner Owners Manual - Page 452

06 06.07 Checking and replacing fuses Type A Type A fuses can be pulled out by using the pull−out tool. The location of the pull− out tool is shown in the illustration. If you are not sure whether the fuse has blown, try replacing the suspected fuse with one that you know is good. If the fuse has blown, push a new fuse into the clip. Only install a fuse with the amperage rating designated on the fuse box lid. If you do not have a spare fuse, in an emergency you can pull out the "PWR OUTLET" or "HEATER NO.2" fuse, which may be dispensable for normal driving, and use it if its amperage rating is the same. If you cannot use one of the same amperage, use one that is lower, but as close to the rating as possible. If the amperage is lower than that specified, the fuse might blow out again but this does not indicate anything wrong. Be sure to get the correct fuse as soon as possible and return the substitute to its original clip. It is a good idea to purchase a set of spare fuses and keep them in your vehicle for emergencies. CY73033 Good Type B Blown CY73023 Good Type C Blown If the headlights or other electrical components do not work, check the fuses. If any of the fuses are blown, they must be replaced. See "Fuse locations" on page 414 in Section 7−1 for locations of the fuses. Turn the ignition switch and inoperative component off. Pull the suspected fuse straight out and check it. Determine which fuse may be causing the problem. The lid of the fuse box shows the name of the circuit for each fuse. See page 452 in Section 8 for the functions controlled by each circuit. Good Blown 436 2007 4Runner from Aug. '06 Prod. (OM35866U)