2007 Toyota 4Runner Owners Manual - Page 52

06 06.07 WHEN THE SYSTEM IS SET Activating the system The system will sound the alarm under the following conditions: Stopping the alarm The alarm will be stopped by the following these ways: TESTING THE SYSTEM 1. Open all the windows. 2. Set the system as described above. The side doors and back door should be locked with the key or wireless remote control transmitter. Be sure to wait until the indicator light goes off or starts flashing. 3. Unlock any side door from the inside. The system should activate the alarm. 4. Stop the alarm as described above. 5. Repeat this operation for the other doors and hood. When testing the hood, also check that the system is activated when the battery terminal is disconnected and then reconnected. If the system does not work properly, have it checked by your Toyota dealer. D Unlock any of the side doors or the back door with the key or wireless remote control transmitter. D If any of the side doors is unlocked or opened without the key or wireless remote control transmitter, or if the back door or hood is forcibly opened. D Turn the ignition key from the "LOCK" to "ON" position. These ways cancel the system at the same time. If the battery becomes discharged due to the vehicle being unused for a long time, etc., when the battery is recharged or replaced, the system will give the alarm. If this happens, immediately unlock any of the side doors or the back door with the key or the wireless remote control transmitter, and the alarm will stop. D If the battery terminal is disconnected and then reconnected. D If the ignition is hotwired. The indicator light will come on when the system is activated. If the alarm has been activated and the key is not in the ignition switch, all the side doors and back door will re−lock automatically. After one minute, the alarm will automatically stop and the indicator light will starts flashing again. Reactivating the alarm Once set, the system automatically resets the alarm after the alarm stops. The alarm will activate again under the same circumstances described in "Activating the system". 36 2007 4Runner from Aug. '06 Prod. (OM35866U)