2007 Toyota Land Cruiser Owners Manual - Page 198

NOTICE z If you change the vehicle height frequently, the pump may overheat. To prevent this, the active height control suspension should be stopped temporarily for a minute between selections. Operate it again. z Before you lower the vehicle height with the height select switch, check under the vehicle to make sure nothing to damage the vehicle or no one to be injured is there and that the underbody of the vehicle does not touch the ground. z After unloading, the height of a vehicle equipped with the active height control suspension becomes slightly higher than the normal vehicle height. Take sufficient care where the overhead height is restricted. The vehicle height cannot be raised if the vehicle load exceeds the following limits: D Up to 4 occupants∗ plus about 280 kg (617 lb.) in the normal mode D Up to 4 occupants∗ plus about 150 kg (331 lb.) in the high mode ∗: About 75 kg (165 lb.) for a person (d) Vehicle height adjustment To change the mode, push the height select switch on either side of " "(higher) and " "(lower). The height control indicator light indicates which mode is selected. (See "(f) Height control indicator lights" described below.) If the above load capacity is exceeded, the desired vehicle height may not be obtained even if the height select switch is pushed. (If the vehicle height cannot be raised in the normal mode and the height control indicator indicates "LO", this is because the vehicle is loaded too heavily. Under these conditions, drive your vehicle with due care.) If the vehicle height cannot be raised even after unloading, push the height select switch on the " " side and then on the " " side. If this does not work, turn off the ignition once and then turn on. Operate the select switch again. If the vehicle height is adjusted slope, or with the selector lever in tion other than "P" or "N" while the is stopped, you may hear a sound by the expansion and contraction propeller shaft. on the a posivehicle caused of the 170