2007 Toyota Land Cruiser Owners Manual - Page 249

6. Repeat steps 2 through 5 for each remaining HomeLinkR button to program another device. Programming a rolling code system If your device is "Rolling Code" equipped, it is necessary to follow steps 1 through 4 under the heading "Programming the HomeLinkR" before proceeding with the steps listed below. 19C516 1. Locate the "training" button on the ceiling mounted garage door opener motor. The exact location and color of the button may vary by brand of garage door opener. Refer to the owner's guide supplied by the garage door opener manufacturer for the location of this "training" button. 2. Press the "training" button on the ceiling mounted garage door opener motor. Following this step, you have 30 seconds in which to initiate step 3 below. 5. Test the operation of the HomeLinkR by pressing the newly programmed button. If programming a garage door opener, check to see if the garage door opens and closes. If the garage door does not operate, identify if your garage transmitter is of the "Rolling Code" type. Press and hold the programmed HomeLinkR button. The garage door has the rolling code feature if the indicator light (on the HomeLinkR) flashes rapidly and then remains lit after 2 seconds. If your garage transmitter is the "Rolling Code" type, proceed to the heading "Programming a rolling code system". 3. Press and release the vehicle's programmed HomeLinkR button twice. The garage door may open. If the door does open, the programming process is complete. If the door does not open, press and release the button a third time. This third press and release will complete the programming process by opening the garage door. The ceiling mounted garage door opener motor should now recognize the HomeLinkR unit and be able activate the garage door up/down. 4. Repeat steps 1 through 3 for each remaining HomeLinkR button to program another rolling code system. 221