2007 Toyota Sienna Owners Manual - Page 44

07 SIENNA_U (L/O 0612) Automatic operation: Type A-Push the switch completely down and then release it. The window will fully open. To stop the window partway, lightly pull the switch up and then release it. Type B-Push the switch completely down or pull it completely up, and then release it. The window will fully open or close. To stop the window partway, lightly move the switch in the opposite direction and then release it. Type A (to open only) If the battery is disconnected or run down, the power window may not operate automatically and the jam protection function will not function correctly after you reconnect, replace or recharge the battery. In any of these cases, you should normalize the power window. To normalize the power window: 1. Push down the power window switch and lower the window halfway. 2. Pull up the switch until the window closes and hold the switch for a second. Make sure that the window opens and closes automatically. If the power window cannot be operated properly, have it checked by your Toyota dealer. Jam protection function (type B only): During automatic closing operation, the window stops and opens half way if something gets caught between the window and window frame. If the window receives a strong impact, this function may work even if nothing is caught. CAUTION D Never try jamming any part of your body to activate the jam protection function intentionally, as it could result in death or serious injury. D The jam protection function may not work if something gets caught just before the window is fully closed. Type B (to open and close) 44 2007 SIENNA from Oct. '06 Prod. (OM45437U)