2007 Toyota Sienna Owners Manual - Page 486

07 SIENNA_U (L/O 0612) Checking power steering fluid If the level is low, add SAE J1703 or FMVSS No.116 DOT 3 brake fluid to the brake reservoir. Remove and replace the reservoir cap by hand. Fill the brake fluid to the dotted line. This brings the fluid to the correct level when you put the cap back on. Use only newly opened brake fluid. Once opened, brake fluid absorbs moisture from the air, and excess moisture can cause a dangerous loss of braking. When the brake fluid must be replaced, contact your Toyota dealer. NOTICE If you spill some of the fluid, be sure to wipe it off to prevent it from damaging the parts or paintwork. If cold O.K. Close If hot O.K. Open If cold add If hot add CAUTION Take care when filling the reservoir because brake fluid can harm your hands or eyes. If fluid gets on your hands or in your eyes, flush the affected area with clean water immediately. If you still feel uncomfortable with your hands or eyes, go to the doctor. Check the fluid level through the reservoir. If necessary, add automatic transmission fluid DEXRONr II or III. If the vehicle has been driven around 80 km/h (50 mph) for 20 minutes (a little more in frigid temperatures), the fluid is hot (60_C-80_C or 140_F-175_F). You may also check the level when the fluid is cold (about room temperature, 10_C-30_C or 50_F-85_F) if the engine has not been run for about five hours. 486 2007 SIENNA from Oct. '06 Prod. (OM45437U)