2007 Toyota Sienna Navigation Manual - Page 158

AUDIO/VIDEO SYSTEM Turn the knob clockwise to step up the station band or counterclockwise to step down. Your radio automatically changes to stereo reception when a stereo broadcast is received. "ST" appears on the screen. If the signal becomes weak, the radio reduces the amount of channel separation to prevent the weak signal from creating noise. If the signal becomes extremely weak, the radio switches from stereo to mono reception. In this case, "ST" disappears from the screen. (b) Presetting a station 1. Tune in the desired station. 2. Touch one of the touch−screen buttons (1 - 6) you want and hold it until a beep is heard. This sets the station to the touch−screen button and the frequency appears on the touch−screen button. Each radio mode (AM, FM1 or FM2) can store up to 6 stations. To change the preset station to a different one, follow the same procedure. The preset station memory is cancelled when the power source is interrupted by battery disconnection or a blown fuse. (c) Selecting a station Tune in the desired station using one of the following methods. Preset tuning: Touch the touch−screen button (1 - 6) for the station you want. The touch−screen button is highlighted and the station frequency appears on the screen. Seek tuning: Push the "SEEK/TRACK" button on either side. The radio will begin seeking up or down for a station of the nearest frequency and will stop on reception. Each time you push the button, the stations will be searched automatically one after another. To scan all the frequencies: Touch "SCAN" on the screen or push the "SCAN" button briefly. "SCAN" appears on the screen. The radio will find the next station and stay there for a few seconds, and then scan again. To select a station, touch "SCAN" or push the "SCAN" button again. To scan the preset stations: Touch "SCAN" on the screen or push the "SCAN" button for longer than a second. "P. SCAN" appears on the screen. The radio will tune in the next preset station, stay there for a few seconds, and then move to the next preset station. To select a station, touch "SCAN" or push the "SCAN" button again. 158