2007 Toyota Tundra Owners Manual - Page 238

07 04.26 (d) Using engine braking To use engine braking, you can downshift the transmission as follows: D When driving in the "D" position- Shift the selector lever to the "S" position. When driving in the "6" range within the "S" position- Move the selector lever down to the " −" side to select the "5" range. The transmission will downshift to fifth range when the vehicle speed drops down to or lower than the following speed, and engine braking will be enabled. 5.7 L V8 (3UR−FE) engine Four −wheel drive models -Front drive control switch knob at "4L" ...79 km/h (49 mph) When the cruise control is being used, even if you downshift the transmission, engine braking will not be enabled because the cruise control is not cancelled. However, engine braking will be automatically enabled if the vehicle speed is higher than the set speed of the cruise control depending on the driving conditions. For ways to decrease the vehicle speed, see "Cruise control" on page 259 in this Section. When the cruise control is being used, even if you downshift the transmission, engine braking will not be enabled because the cruise control is not cancelled. However, engine braking will be automatically enabled if the vehicle speed is higher than the set speed of the cruise control depending on the driving conditions. D Move selector lever down to the "−" side to select the "3" range. The transmission will downshift to third range when the vehicle speed drops down to or lower than the following speed, and more powerful engine braking than that of the "4" range position will be enabled. D Move the selector lever down to the " −" side to select the "4" range. The transmission will downshift to fourth range when the vehicle speed drops down to or lower than the following speed, and stronger engine braking will be enabled. 5.7 L V8 (3UR−FE) engine Four −wheel drive models -Front drive control switch knob at "4L" ...79 km/h (49 mph) 220 2007 TUNDRA from Jul. '07 Prod. (OM34463U)