2007 Toyota Tundra Owners Manual - Page 77

07 04.26 -Raising rear seat cushion (Double cab models) 1. SEAT POSITION ADJUSTING LEVERS Hold the center of the lever and pull it up. Then slide the seat to the desired position with slight body pressure and release the lever. 2. SEATBACK LEVERS ANGLE ADJUSTING D Avoid reclining the seatback any more than needed. The seat belts provide maximum protection in a frontal or rear collision when the passengers are sitting up straight and well back in the seats. If you are reclined, the lap belt may slide past your hips and apply restraint forces directly to the abdomen or your neck may contact the shoulder belt. In the event of a frontal collision, the more the seat is reclined, the greater the risk of death or serious injury. XS13146b Pull the lever up. Then lean back to the desired angle and release the lever. CAUTION D Do not adjust the seat while the vehicle is moving. BEFORE RAISING REAR SEAT CUSHION 1. Stow the rear seat belt buckles as shown in the illustration. This prevents the seat belt buckles from falling out when you fold the seatback. D Be careful that the seat does not hit a passenger or luggage. D After adjusting the seat position, release the lever and try sliding the seat forward and backward to make sure it is locked in position. D After adjusting the seatback, push your body back against the seat to make sure the seat is locked in position. NOTICE The seat belt and buckles must be stowed before you raise the rear seats cushion. NOTICE Do not fold the rear seat seatback forward with the luggage cover hooks attached. 2007 TUNDRA from Jul. '07 Prod. (OM34463U) 59