2008 Toyota 4Runner Owners Manual - Page 235

2008 Toyota 4Runner Manual

Page 235 highlights

07 12.25 To change the "LO" mode to "HI", push the switch twice. It takes about 30 seconds until the "LO" mode changes to the "HI" mode. Selecting the "N" mode- NOTICE z If the vehicle height is changed frequently when the vehicle is heavily loaded, the compressor may overheat, causing the vehicle height adjustment operation to stop. z Before you lower the vehicle height with the height select switch, check under the vehicle to make sure nothing to damage the vehicle or no one to be injured is there and that the underbody of the vehicle does not touch the ground. z After unloading, the height of a vehicle equipped with the rear height control air suspension becomes slightly higher than the normal vehicle height. Take sufficient care where the overhead height is restricted. z Do not select the "LO" mode in the bumpy roads. If the underbody of the vehicle touches the rugged road surface, the vehicle may be damaged. CY16014 To change the "HI" mode to "N", push the height select switch on the " Ɲ" side once. To change the "LO" mode to "N", push the height select switch on the " Ɯ" side once. Selecting the "LO" mode- Push the height select switch on the " Ɲ" side while the vehicle is stopped. To change the "N" mode to "LO", push the switch once. To change the "HI" mode to "LO", push the switch twice. Even if the engine is stopped while the vehicle height is being lowered, the operation continues for up to 25 seconds. If, within this 25 seconds, any of the side doors or the back door is opened, operation will continue for a further 15 seconds. (c) Vehicle height adjustment To change the mode, push the height select switch on either side of "Ɯ" (higher) or "Ɲ" (lower). The height control indicator light indicates which mode is selected. (See "(e) Height control indicator light" described below.) Selecting the "HI" mode- Push the height select switch on the " Ɯ" side when the vehicle speed is under about 30 km/h (19 mph). To change the "N" mode to "HI", push the switch once. 193

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.