2008 Toyota 4Runner Owners Manual - Page 293

07 12.25 -DVD player The DVD player can play audio CDs/ MP3 CDs, DVD video discs, CD texts, dts−CDs and video CDs. For appropriate discs for this player, see "Audio/video system operating hints" on page 280 in this Section. The DVD player works when the engine switch is in the "ACC" or "ON" position. To turn on the DVD player, a disc must be loaded in the player. To turn off the player, eject the disc. Error messages Vehicles with navigation system- Push the "INFO" button to change the screen to "Screen Setting". Push the "ON" switch on the "Screen Setting" screen to turn on the "Rear system lock". Then push "OK". When the rear system lock is on and any button is pushed on the remote controller or the operation panel, the screen shown above is displayed for approximately 6 seconds. Even when the rear system lock is turned on during play mode, the images and sounds continue without interruption. The condition of the rear system lock is maintained, even when the engine switch is turned off. If the player malfunctions, your audio system will display following error messages. If "DISC CHECK" appears on the screen: It indicates that the disc is dirty, damaged or it was inserted upside down. Clean the disc or insert it correctly. If "REGION CODE ERROR" appears on the screen: It indicates that the DVD region code is not set properly. If "DVD ERROR" appears on the screen: There is a problem inside the player. Eject the disc. Set the disc again. If the malfunction still exists, take your vehicle to your Toyota dealer. Z18031E Z17443 251