2008 Toyota 4Runner Owners Manual - Page 347

07 12.25 -Before using the multi −information display Operate the multi −information display with the engine switch on. When the engine switch is turned to "ON", the last previously used mode displayed just before the engine switch is turned off will appear. If the electrical power source has been disconnected from the multi −information display, the display will automatically be set to the initial mode. -Clock -Outside temperature display (air conditioning system without "DUAL" button) CY19001 CY19082 CAUTION Do not adjust the display while the vehicle is moving. Be sure to adjust the display only when the vehicle is stopped. To reset the hour: Push the "H" button. To reset the minutes: Push the "M" button. If quick adjustment to a full hour is desired, push the ":00" button. For example, if the ":00" button is depressed when the time is between 1:01-1:29, the time will change to 1:00. If the time is between 1:30-1:59, the time will change to 2:00. The engine switch must be in the "ACC" or "ON" position. If the electrical power source has been disconnected from the clock, the time display will automatically be set to 1:00 (one o'clock). The displayed temperature ranges from −30_C (−22_F) up to 50_C (122_F). The engine switch must be in the "ON" position. If an abnormality exists in the connection of the outside air temperature sensor, " −−_C" (" −−_F") will appear on the display. If "−−_C" (" −−_F") appears on the display, contact your Toyota dealer. There may be a case that "−−_C" (" −−_F") appears momentarily when the engine switch is quickly turned to "ON". It is normal if it goes out soon. 305