2008 Toyota 4Runner Owners Manual - Page 451

07 12.25 NOTICE Use only a cable or chain specifically intended for use in towing vehicles. Securely fasten the cable or chain to the towing eyelet provided. Before towing, release the parking brake and put the transmission in "N". The engine switch must be in "ACC" (engine off) or "ON" (engine running). Four −wheel drive models-On multi −mode four −wheel drive models, put the multi − mode control switch knob in "H2". On full − time four −wheel drive models, unlock the center differential. -Emergency towing eyelet precautions D Before emergency towing, check that the eyelet is not broken or damaged and that the installation bolts are not loose. CAUTION If the emergency towing eyelet is used to get out when your vehicle becomes struck in mud, sand or other condition from which the vehicle cannot be driven out under its own power, make sure to observe the precautions mentioned below. Otherwise, excessive stress will be put on the eyelet and the towing cable or chain may break, causing serious injury or damage. D Fasten the towing cable or chain securely to the eyelet. D Do not jerk the eyelet. Apply steady and even force. D To avoid damaging the eyelet, do not pull from the side or at a vertical angle. Always pull straight ahead. D If the towing vehicle can hardly move, do not forcibly continue the towing. Contact your Toyota dealer or a commercial tow truck service for assistance. CAUTION If the engine is not running, the power assist for the brakes and steering will not work so steering and braking will be much harder than usual. D Tow the vehicle as straight ahead as possible. D Keep away from the vehicle during towing. 409