2008 Toyota Sequoia Warranty, Maitenance, Services Guide - Page 46

2008 Sequoia Scheduled Maintenance Guide MAINTENANCE LOG 30,000 Miles or 36 months Lubricate propeller shaft (4WD) Re-torque propeller shaft bolt Replace cabin air filter Replace engine air filter Replace engine oil and oil filter 1 Rotate tires Visually inspect brake linings/drums and brake pads/discs Inspect the following: __ Automatic transmission fluid __ Ball joints and dust covers __ Brake lines and hoses __ Drive shaft boots (4WD) __ Engine coolant 3 __ Exhaust pipes and mountings __ Front differential oil (4WD) __ Fuel lines and connections, fuel tank band and fuel tank vapor vent system hoses 4 Fuel tank cap gasket Radiator and condenser Rear differential oil Steering gear box Steering linkage and boots Transfer case oil (4WD) Additional Maintenance Items for Special Operating Conditions Driving on dirt roads or dusty roads: Tighten nuts and bolts on chassis Driving while towing: Replace front differential oil (4WD) Replace rear differential oil Replace transfer case oil (4WD) Tighten nuts and bolts on chassis 2 DEALER SERVICE VERIFICATION: DATE: MILEAGE: Reset the oil replacement reminder light (ЉMAINT REQDЉ) or the message ЉOIL MAINTENANCE REQUIREDЉ on the multi-information display after engine oil replacement. Perform these service items only if you drive primarily under the conditions indicated. 3 Refer to ЉEngine CoolantЉ in the ЉExplanation of Maintenance ItemsЉ section in the back of this guide for more information. 4 Inspect thickness measurement and disc runout. 2 1 09