2008 Toyota Sequoia Warranty, Maitenance, Services Guide - Page 58

2008 Sequoia Scheduled Maintenance Guide MAINTENANCE LOG 120,000 Miles or 144 Months Lubricate propeller shaft (4WD) Re-torque propeller shaft bolt Replace cabin air filter Replace engine air filter Replace engine oil and oil filter 1 Replace spark plugs 5 Rotate tires Visually inspect brake linings/drums and brake pads/discs Inspect the following: __ Automatic transmission fluid __ Ball joints and dust covers __ Brake lines and hoses __ Drive belts __ Drive shaft boots (4WD) __ Engine coolant 3 __ Engine valve clearance 6 __ Exhaust pipes and mountings __ Front differential oil (4WD) 4 __ Fuel lines and connections, fuel tank band and fuel tank vapor vent system hoses __ Fuel tank cap gasket __ Radiator and condenser __ Rear differential oil __ Steering gear box __ Steering linkage and boots __ Transfer case oil (4WD) Additional Maintenance Items for Special Operating Conditions Driving on dirt roads or dusty roads: Tighten nuts and bolts on chassis Driving while towing: Replace automatic transmission fluid Replace front differential oil (4WD) Replace rear differential oil Replace transfer case oil (4WD) Tighten nuts and bolts on chassis DEALER SERVICE VERIFICATION: 2 DATE: MILEAGE: Reset the oil replacement reminder light (ЉMAINT REQDЉ) or the message ЉOIL MAINTENANCE REQUIREDЉ on the multi-information display after engine oil replacement. Perform these service items only if you drive primarily under the conditions indicated. 3 Refer to ЉEngine CoolantЉ in the ЉExplanation of Maintenance ItemsЉ section in the back of this guide for more information. 4 Inspect thickness measurement and disc runout. 5 Maintenance services of spark plugs are required under the terms of the Emissions Control Warranty. 6 Check for tappet noise and engine vibration and adjust if necessary, 2UZ-FE engine only. 2 1 21