2008 Toyota Sienna Owners Manual - Page 107

08 SIENNA_U (L/O 0801) To make only slight changes to an already memorized position, the easiest way is to first activate the memorized position, then make the desired changes and perform step 2 above. SETTING THE DRIVING POSITION The engine switch must be in the "ON" position and the selector lever is in the "P" position. 1. Adjust the driver's seat and outside rear view mirrors to the desired position. 2. While pushing the "SET" button, push button "1" or "2" until a beep is heard. The system can memorize up to 2 positions by repeating the above steps. If step 2 is performed when both buttons "1" and "2" are memorized, the previous position will be erased and a new position will be set. RECALLING THE MEMORIZED POSITION When you push button "1" or "2", a beep will sound and the driving position will be automatically adjusted to the position recorded for that button. The memorized position can be recalled under the following conditions: D The engine switch is in the "ON position and the selector lever is in the "P" position. D The key is not in the engine switch and less than 30 seconds have passed since opening the driver's door. 66 2008 SIENNA from Aug. '08 Prod. (OM45455U)