2008 Toyota Sienna Owners Manual - Page 217

08 SIENNA_U (L/O 0801) Headlight beam level control TURN SIGNALS To signal a turn, push the headlight/ turn signal lever up or down to position 1. The engine switch must be in the "ON" position. The lever automatically returns after you make a turn, but you may have to return it by hand after you change lanes. To signal a lane change, move the lever up or down to the pressure point (position 2) and hold it. If the turn signal indicator lights (green lights) on the instrument panel flash faster than normal, a front or rear turn signal bulb is burned out. To adjust the headlight beam level, turn the dial. The following list shows examples of proper dial settings. For loading conditions other than those listed, adjust the dial position so that the beam level is the same as the one obtained according to the list when only the driver is in the vehicle. The higher the number of the dial position, the lower the headlight beam level. Always keep the headlight beam at the proper level, or your headlights may dazzle other road users. 176 2008 SIENNA from Aug. '08 Prod. (OM45455U)