2008 Toyota Solara Owners Manual - Page 161

'08 Solara_U (L/O 0802) D When changing the tire inflation pressure by changing traveling speed or load weight, etc. To initialize the system, perform the following: 1. Park the vehicle in a safe place and turn the engine switch to "LOCK" position. 2. Adjust the pressure of all the installed tires to the specified cold tire inflation pressure level. (See "Tires" on page 377 in Section 8.) TIRE PRESSURE SWITCH WARNING RESET 3. Turn the engine switch to the "ON" position. 4. Push and hold the tire pressure warning reset switch until the tire pressure warning light blinks slowly three times. 5. Wait for a few minutes with the engine switch in "ON" position, and then turn the engine switch to the "LOCK" position. If you push the tire pressure warning reset switch while vehicle is moving, initialization is not performed. If you push the tire pressure warning reset switch accidentally and initialization is performed, adjust the tire inflation pressure to the specified level and initialize the system again. If the tire pressure warning light does not blink slowly three times when you push and hold the tire pressure warning reset switch, initialization has failed and the tire pressure warning system may not work properly. In this case, initialize the system again. If initialization cannot be performed, have the system checked at your Toyota dealer. When initializing the system, the present tire inflation pressure is stored as standard. The tire pressure warning system determines decreased air pressure by comparing the present and the standard tire inflation pressures. When you change the set tire inflation pressure, it is necessary to initialize the tire pressure warning system. D When changing the tire size. D When rotating the tire on vehicles differing with front and rear tire inflation pressure. 161 2008 CAMRY SOLARA from Feb. '08 Prod. (OM33810U)