2008 Toyota Tundra Owners Manual - Page 545

07 11.20 -After changing wheels Torque specification: Taper type (Steel wheels)- 209 N·m (21.3 kgf·m, 154 ft·lbf) Flat washer type (Aluminum wheels)- 131 N·m (13.4 kgf·m, 97 ft·lbf)∗ ∗ : When temporarily used on spare tire/wheel, apply 209 N·m (21.3 kgf·m, 154 ft·lbf) 10.Check the air pressure of the replaced tire. Adjust the air pressure to the specification designated on page 594 in Section 8. If the pressure is lower, drive slowly to the nearest service station and fill to the correct pressure. Do not forget to reinstall the tire inflation valve cap as dirt and moisture could get into the valve core and possibly cause air leakage. If the cap is missing, have a new one put on as soon as possible. 11. Restow all the tools, jack and flat tire securely. As soon after changing wheels as possible, tighten the wheel nuts to the torque specified on page 515 with a torque wrench. Have a technician repair the flat tire and replace the temporary spare tire with it. Initial adjustment of the tire pressure warning system is necessary after your have replaced your tires or wheels. See "Tire pressure warning system" on page 254 in Section 1 −7. CAUTION Before driving, make sure all the tools, jack and flat tire are securely in place in their storage location to reduce the possibility of personal injury during a collision or sudden braking. 515 2008 TUNDRA from Apr. '08 Prod. (OM34477U)