2008 Toyota Tundra Owners Manual - Page 590

07 11.20 CHAIN INSTALLATION Side chain G72017 Install the chains on the rear tires as tightly as possible. Do not use tire chains on the front tires. Retighten chains after driving 0.5-1.0 km (1/4-1/2 miles). When installing chains on your tires, carefully follow the instructions of the chain manufacturer. If wheel covers are used, they will be scratched by the chain band, so remove the covers before putting on the chains. CAUTION D Do not exceed 50 km/h (30 mph) or the chain manufacturer's recommended speed limit, whichever is lower. Cross chain D Drive carefully avoiding bumps, holes, and sharp turns, which may cause the vehicle to bounce. braking, as use of chains may adversely affect vehicle handling. D Avoid sharp turns or locked−wheel D When driving with chains installed, be sure to drive carefully. Slow down before entering curves to avoid losing control of the vehicle. Otherwise an accident may occur. TIRE CHAIN SELECTION Use the tire chains of correct size. Use the following type chains. A Diameter of side chain: B Diameter of cross chain: mm (in.) 5.0 (0.20) 6.3 (0.25) NOTICE Snow tires or chains may affect the tire pressure warning system. See "Tire pressure warning system" on page 254 in Section 1−7. Regulations regarding the use of tire chains vary according to location or type of road, so always check local regulations before installing chains. NOTICE If the wrong combination of tire and chain is used, the chains could damage the vehicle body. 560 2008 TUNDRA from Apr. '08 Prod. (OM34477U)