2008 Toyota Tundra Owners Manual - Page 598

07 11.20 Replacing light bulbs- The following illustrations show how to gain access to the bulbs. When replacing a bulb, make sure the engine switch and light switch are off. Use bulbs with the wattage ratings given in the table. The side turn signal lights consist of a number of LEDs. If any of the LEDs burn out, take your vehicle to your Toyota dealer to have the light replaced. The inside of the lens of exterior lights such as headlights may temporarily fog up when the lens becomes wet in the rain or in a car wash. This is not a problem because the fogging is caused by the temperature difference between the outside and inside of the lens, just like the windshield fogs up in the rain. However, if there is a large drop of water on the inside of the lens, or if there is water pooled inside the light, contact your Toyota dealer. Light bulbs Headlights (high beam) Headlights (low beam) Front fog lights Parking and front side marker lights Front turn signal/parking lights Rear turn signal lights Stop/tail and rear side marker lights Back −up lights License plate lights High mounted stoplight and cargo lamps Interior lights Bulb No. 9005 - 9145 168 4157 NAK 3157A 3157 921 168 921 - W 65 55 45 5 27/8 Type A B C D E CAUTION D To prevent burning yourself, do not replace the light bulbs while they are hot. D Halogen bulbs have pressurized gas inside and require special handling. They can burst or shatter if scratched or dropped. Hold a bulb only by its plastic or metal case. Do not touch the glass part of a bulb with bare hands. 27/8 27/8 18 4.9 18 5 E D D D D D NOTICE Only use a bulb of the listed type. 568 2008 TUNDRA from Apr. '08 Prod. (OM34477U)