2008 Toyota Tundra Owners Manual - Page 70

07 11.20 SETTING THE SYSTEM 1. Turn the key to the "LOCK" position and remove it. The indicator light will start flashing when the key is removed from the engine switch. (See "Engine immobilizer system" on page 21 in this Section for details.) 2. Have all passengers get out of the vehicle. 3. Close and lock all the doors and hood. The indicator light will remain on when all the doors and hood are closed and locked. The system will automatically be set after 30 seconds. When the system is set, the indicator light will start flashing again. 4. After making sure the indicator light starts flashing, you may leave the vehicle. WHEN THE SYSTEM IS SET Activating the system The system will sound the alarm under the following conditions: XS12001 D If any of the doors is unlocked or opened without the key or wireless remote control transmitter, or if the hood is forcibly opened D If the battery terminal is disconnected and then reconnected Vehicles with the glass breakage sensor- Indicator light D The side windows are tapped or broken. The indicator light will come on when the system is activated. If the alarm has been activated and the key is not in the engine switch, all the doors will re−lock automatically. After one minute, the alarm will automatically stop and the indicator light will start flashing again. XS12027a Never leave anyone in the vehicle when you set the system, because unlocking from the inside will activate the system. Glass breakage sensor (on some models) 40 2008 TUNDRA from Apr. '08 Prod. (OM34477U)