2009 Toyota 4Runner Warranty, Maitenance, Services Guide - Page 15

MAINTENANCE LOG 60,000 Miles or 72 months Lubricate propeller shaft (4WD) Re-torque propeller shaft bolt Replace cabin air filter Replace engine air filter Replace engine oil and filter 1 Replace spark plugs (1GR-FE engine only) Rotate tires Inspect the following: __ Automatic transmission fluid __ Ball joints and dust covers __ Brake lines and hoses __ Brake linings/drums and brake pads/discs __ Charcoal canister 7 __ Drive belts 8 __ Drive shaft boots (4WD) __ Engine coolant 3 __ Engine valve clearance 9 __ Exhaust pipes and mountings 5 6 __ Front differential oil (4WD) __ Fuel lines and connections, fuel tank band and fuel tank vapor vent system hoses __ Fuel tank cap gasket __ Radiator and condenser __ Rear differential oil __ Steering gear box __ Steering linkage and boots __ Transfer case oil (4WD) 2 Additional Maintenance Items for Special Operating Conditions Driving on dirt roads or dusty roads: Tighten nuts and bolts on chassis and body Driving while towing: Replace automatic transmission fluid Replace front differential oil (4WD) Replace rear differential oil Replace transfer case oil (4WD) Tighten nuts and bolts on chassis and body DEALER SERVICE VERIFICATION: DATE: MILEAGE: Reset the oil replacement reminder light (ЉMAINT REQDЉ) or the message ЉOIL MAINTENANCE REQUIREDЉ on the multi-information display after engine oil replacement. Perform these service items only if you drive primarily under the conditions indicated. 3 Refer to ЉEngine CoolantЉ in the ЉExplanation of Maintenance ItemsЉ section in the back of this guide for more information. 4 Includes operating on roads which road salt has been applied. 5 Maintenance services of spark plugs are required under the terms of the Emissions Control Warranty. 6 Inspect thickness measurement and disc runout. 7 For vehicles registered in California, Massachusetts and New York States only. 8 Initial inspection at 60,000 miles/72 months. Inspect every 15,000 miles/18 months thereafter. 9 Check for tappet noise and engine vibration and adjust if necessary. 2 1 13